Mountfield 2125 H User Manual download pdf (Page 14)

ENGLISH

1 GENERAL

This symbol indicates CAUTION. Seri-

ous personal injury and/or damage to

property may result if the instructions

are not followed carefully.

You must read these instructions for

use and the machine’s safety instruc-

tions and instructions for use carefully.

1.1 References

The figures in these instructions for use are num-

bered 1, 2, 3, etc.

Components shown in the figures are marked A, B,

C, etc.

A reference to component C in figure 2 is written

“2:C”.

2 SAFETY INSTRUCTIONS

• Please read through these instructions carefully.

Learn all the controls and the correct use of the

unit.

• Carefully read and understand the safety in-

structions supplied by GGP in a separate book

together with the machine.

3 DESCRIPTION

3.1 General

The quick connections are intended for use on

GGP’s machines Stiga Villa, Castelgarden XM

and Mountfield 2125 and 2135.

The quick connections can be separated, which

makes it very easy to shift between the different

implements.

The quick connections allow the deck to be moved

easily between the two positions:

• Normal position with fully tensioned belt.

• 4 cm behind the normal position with slackened

belt so that the deck gets closer to the base ma-

chine.

As the belt idler is released from the belt, the quick

connections simplify belt and deck replacement,

and also make shifting to the washing position and

service positions easier.

3.2 Delivery

The delivery consists of the following compo-

nents. The figures only display the right-hand side,

but the numbers below refer to both sides.

4 ASSEMBLY

Install the quick connections according to the in-

structions below.

1. Install the deck sections of the quick connec-

tions to the deck arms according to fig. 2.

Note! If snow chain is used in combina-

tion with the Quick connection the

screw has to be mounted with the head

pointing towards the machine. See fig.

11.

2. Install the shaft sections of the quick connec-

tions to the machine according to fig. 1 and fig.

3. Set the mountings to their rear positions and

hook the deck arms into position. See fig. 4.

4. If the belt is mounted, the belt tension can be re-

leased by unhooking the belt idler from the belt.

See fig. 6.

5. Set the quick connections to their front posi-

tions and install the locking pins (5:A).

6. Lubricate the lubricating cup for the quick con-

nection using a grease gun until grease pene-

trates alongside the shaft. See fig 7.

Position fig 1, 2, 3

A 2 locking pins

B Quick connection deck section, right and

left

C Quick connection shaft section, right and

left

D 2 screws

E2 nuts

F 2 spacers

G 2 washers

H 2 washers

I2 lock rings

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Comments to this Manuals

No comments

Mountfield 2125 H User Manual Page 14

Comments to this Manuals